info@freeflush.co.uk

Installation

Prestige Water Butt The Original Wall Mounted Water Butt

The Prestige Water Butt combines both a diverter and a reservoir in one unique product. Excess water overflows automatically and safely into the downpipe and on into your drain. When full and containing 22 galls (100ltrs) natural expansion of the reservoir will occur, both the reservoir and fixings have been designed to accommodate this. In winter drain by fitting a length of hose from the tap (left in the open position) directly into your drain. You may add to the charm of your waterbutt by inserting flower pots into the two top holes, ensure that these do not sit below the overflow point. The higher the waterbutt is placed on the wall the greater the ‘head’ of water pressure, thus enabling direct hosing of your plants. More than one butt can be connected together for increased storage capacity.

Contents Checklist:

1 Wallmounted Waterbutt
1 Wall bracket
6 screws and plugs
1 Tap
1 Tap bung (factory fitted)
2 Top caps (factory fitted)
1 Installation instruction sheet

Fixing Instructions:

Follow these instructions carefully, all brackets and fixings must be used correctly.

 

 

 

 

 

 

 

 

 

  • Decide Height

    Step 1

    Decide the height and position at which you wish to fix the waterbutt, remember to allow enough room for your watering can under the tap. The suggested height is 400mm (16”) at this point mark a level line on the wall A

  • Bottom Pipe Clips

    Step 2

    Any bottom pipe clip must be 100mm (5" ) below the waterbutt, if necessary reposition B

  • Outlet Section Cuts

    Step 3

    Measure 1075mm  (42 ½”) up from height line A and cut horizontally through the pipe. Now mark 140mm  (5 ½”) above this cut and once again cut and remove this section C

  • Top Pipe Clips

    Step 4

    Ensure that any top clip is positioned at a minimum of  240mm  (9 ½”) above the top of reservoir D for ease of fitting.

  • Fixing Wall Bracket

    Step 5

    Taking the metal wall bracket E slide down the pipe via the cut section to align the protruding arms with height line A check that the bracket is dead centre of the pipe and that it is level (Use a spirit level). Mark the holes and drill two 10mm holes and using the two short plugs and

  • Fitting the Water Butt

    Step 6

    Offer up the water butt to the top down pipe sliding it inside the centre hole of the butt until it will go no further. With the butt against the wall, lower it onto the bottom pipe section. Now with butt seated level and evenly on the brackets, mark the position dead centre of the

  • Fixing the Waterbutt

    Step 7

    Fit the bung to the side you DO NOT want the tap, in case of limited access when in position. Now repeat step 6. Once again with the butt in place, push the long plugs through the top holes of the butt and fix to the wall. Finally fit the tap and push the top